Additional pictures available upon request. All prices include shipping and insurance.

10mil Big Block Twister $2300
-Rotax powervalves
-Vforce 3
-Upp intakes
-25cc Domes
-76mm bore
-New O-Ring kit

10mil 125rod Twister Crank $700
-TZ bearing

2-5 Override $325
-Cut by WCR

Straight-Cut gears $275
-2.76 ratio

22x12x10 12-paddle SLS Haulers $375
-Douglas .125 rims

Cases $300
-Bored to fit big bore cylinders
-Trenched for 10mil crank w/ 125 rods
-Port-matched to Cylinders listed above
-All work done by Cascade Innovations

38mm Mikuni Flatslides (Alky) $450
-Billet Bowls
-Dave Moore Superjets
-Set up by Cascade Innovations

Shearer Hand-Coned OOF Pipes $450
-Out clutch side
-chrome
-flanges for silencers
-Big Flange



Twister Cylinders


Twister 10mil crank




2-5 Override




Straight-Cuts




Carbs


Cases




Pipes




There are two small dings on the cone on the top pipe. See pic.

I ran cascade silencers on these pipes. I am keeping the silencers to use on other bikes, but I do have the stingers. You'd just need to get the stingers welded to the little washer so you could bolt them up to the pipes, or run a set of silencers. I'm sure matt at shearer could weld the stingers to a flange for next to nothing. There are two small dings in the cone on the upper pipe. (see pic) Both dings are about half the size of a dime.

Thanks for looking
- Jared

You sure the gears are 2:76's?

Count the teeth in the pic... 25x69 That's 2.76.

Ok just curious. I know they dont make 2:76's but I know mark can make them in any ratio

Pipes sold pending payment.

PIPES SOLD.

Bumpity!

Thanks, but I'm already more than well equipped in that department.

Bump! Offers?