Black Label Chassis +12 out front and 5 out the back with bar
99mm bore ice cube cyl and piston 13:1
2mil crank works crank with falicon rod
cut tranny 1-3
head ported by peter- drag port
44mm lectron on alky
ron woods pug
direct drive lockout clutch
brand new stator and rectifier
cold fusion nitrous system with w.o.t setup
electric start
drag axle
alum drag tank

Bike made 59 hp and mid 40's tq on motor and never dynoed on spray. Went 4.52 on motor with a 165lb rider at pops a few weekends ago first pass off the trailer with 12 paddle rippers and nitrous gearing, fuel pump went out that day so I didnt get to spray it.I have the slip if needed.

Setup for banshee seat and front fender and torchworks radiator.

$4500- call mark at 337-967-2554 or pm me. Located in Lafeyette La

this was built by L.R.E. not by black label racing

do you want to sale rippers

bump for a killer deal. I'm helping Mark with parting this thing out, so pm me or him with questions.

$1550 for everything left!! Includes frame, steering, seat, tank, drag axle with carrier, brake setup with rotor

motor, pipe, carbs, nitrous, electronics all SOLD. Wheels/tires not for sale.

axle sold.. will accept offers on frame

whats the weight of the chassis as your selling it?

it weighs 78#s as it sits. frame, steering stem, spindles, tierods, brake pedal & rezzy, axle w/ hubs, master cylinder, rotor, sproket, chain guide, tank, seat, misc. nuts/bolts.
*** axle and carrier is sold, didn't pull it off yet.

new pics...

bump

SOLD

do u know where i can find a wheelie bar for a 400ex

If you're around the Breaux Bridge area call Luke to build you one.. three three seven-three two two-eight five six nine