I have for sale my 1985 Atc 250r Drag trike. It has been built from the ground up. The frame has been lightened, smoothed and powder coated. Everything that wasn’t necessary came off of the frame. The rear brake lever has been removed and shaved. I got a lightweight Front master cylinder with shorty lever from a KX450R and ran a steel braided line all the way to the rear caliper. This is a very nice lightweight setup. It’s very unique. It has a +12” over lightweight swing arm that has been setup for no link and a 40mm carrier. It has a JJ&A rear single row 40mm carrier with a JJ&A hill shooter 28” billet drag axle. The axle has Yamaha pattern hubs. The engine is a 370 Sphynx motor that was done by Nate Mccoy. It has an Oem crank that has been stroked, welded, balanced and lightened. I just put a fresh top end in it which has about one hour on it. It has a 1-4 override transmission, billet clutch basket, CR springs and a new Oem clutch. It has CR ignition from ESR with the small flywheel. The carb is a 42mm Lectron on methanol with a Mikuni fuel pump. The cases are original and have never been broken by the chain. The pipe is a custom pipe built by Shearer Custom Pipes. The front fender and tank plastics are new Oem and the tank has been restored. The seat and rear plastics are also original. The triple clamps and front forks have been fully polished. It has a Mohawk front tire with a Douglas 11“ wheel in front and 8 paddle triple buff SLS haulers in the rear. This bike also comes with a 5 foot long wheelie bar and a rear strut if you would like to set it up for flat sand drags. I am located in Auburn, Ca. $4000.00 OBO text 916-257-8087

Badass trike!

very nice!!!!

bump $3500 obo

bump for $3000.00

to the top...