I'm new to the site and I'm trying to find out how to mount wheelie bars to the quad. I plan on making a set for my banshee and my yfz450. Thanks for the help.
Mike

well I have only looked at them and helped friends mount them but they usually bolt to the tightening bolts on a round carrier just use longer bolts or you can use the skid plate mounts on a stock swinger. for the top just go back to your frame like where your grab bar mounts or add some mounting tabs. hope this helps.

on a banshee you can weld a bracket together to bolt up to the back of the swingarm.....and make a small bracket that attaches to the frame for the top....works pretty well!!!!!!!!

heres some pics of mine and how it hooks to swingarm and subframe, pics are to follow, it a 3 bar, 2 on bottumn and 1 on top, i don`t know the id of tubing but do know it chromoly and uses heims to bolt to lower carrier bolts and upper frame

another pic

last pic

Would 1" .058 chromoly be to large and not allow enough flex?

i measured the bars on mine and the top bar was .80 and it in 2 pieces, with the inside piece bout 3 frts as long as lower section , it slides and pins for wheel height adjustment, that section was 60ths, both the lower pieces were 58 ths , all the figures were od and with chrome on, i don`t know the id of tubing, but has held up fine, so hope this helps some

Thanks Frank I think I'll go with 3/4 .058
I built a top mount like yours after seeing the pics you posted. Worked great!

any time, you can ask any of the racers on here that run at our track and they can attest that my bar has been well tested for strength, not on purpose of course, and my upper bracket is mild steel square tubing with 1\4 in brackets, welded to frame, it has held fine, and the upper support bar islike double with the long inside piece sliding down into lower section, i bought it used and was told brooks racing built it, hope this helps you out some, usually everybody can benifit from my experances,lol