Just wondering if any were there and what kind of times they were running.Pictures?

Dont think there were any there. But I know of one that runs consistent 4.7's on alky with a 220lb rider aboard. Oh yeah, it carries the front wheels to about the 150lb mark too.

For a heavy polaris,I think those are some impressive times.
I might be building one sometime in the future.

I know mines not the fastest but it runs 5.1 on gas.

That sounds good to me.
With alcohol,it should go into the 4's pretty easy I would think.

Yeah, I still have a few pounds that I need to shave off of it too.

With alcohol,it should go into the 4's pretty easy I would think. [/quote]
hey can you take the stock mukuni carb and put it on alky.if yes what should i do,drill the jets,if yes what size should they be drilled,i already have a power jet.

I'm not sure but I think you would need a bigger carb to run alky.

hey where do u put the oil in at on the 400 4x4 scrambler right behind the cylinder is a dipstick i now that you gotta put 3 oz there but where else do u put it at

is that 300ft and is it a 400 or is it stroked. we have run 4.90 no stroke ,on stock frame nothing cut but the plastic (all throttle no bottle)no spray. oh yeah it's a 400 express not a scrambler. just wondering

This is stock stroke, power maxx 416, drag chassis on alky. Its very impressive. Very strong out the gate.

[quote]This is stock stroke, power maxx 416, drag chassis on alky. Its very impressive. Very strong out the gate. [/quote] my polaris runs 4.9s on gas dont know the time on alky yet see this weekend and its not a hpd motor its a 470 motor

Did you run the 4.9 on sand or dirt ?
The 4.7 above was on very soft sand with a 220 lb rider.

my 4.9 was on a dirt track in ohio i am 185lbs my dad ran it last weekend and it ran 5.3 on a pee gravel track at an old gravel pit its a bad track for us but it lost the piston on that pass too so it would have been faster

4.9 is very good times for a stock framed 400. Nothing to take away from ced's quad, I have raced him many times and always end up seeing the back of his quad at the finish line.

this bike is the aaen 470 motor with his drag pipe and an ecw frame

[/quote] this bike is the aaen 470 motor with his drag pipe and an ecw frame.

How do you like the aaen drag pipe?

4.90 stock frame drag pipe on clay running pro wedge tires
no stroke( stock crank)
on alky
no spray(nos)
190lb rider

Good job.

thanks, still looking for a little more

any help or ideas??????????