anyone have pics, my bike is stock frame with stock rear shock,with a round house anyone have pics on where to mount, i can weld tabes any wher but where are the point the bars should go to

most people weld 2 tabs on the underneath of the swingarm and if you are running a shock you will want to stay down on the swingarm. we weld a piece of tubing up off the carrier and another as a brace back to the shock mount then use an adjustable eye up top in order to raise and lower the bar it's easy on easy off and works great

much appreciated dirtdraggin440 do you have any close up pics if so can you email them to highroller355@aol.com

Heres a pic I have of mine. I have it on mounts under my swinger but I have seen them on the pinch bolts also and that would be a lot easier. I run a strut and attach the top bar to it.

I made a couple similar to dune jumpers .I pull 3 pins and it's off in 20 seconds.

I like the way that looks!! what size tubing?

That is 3/4 X .058 chromoly. Next time I will use a thicker wall for the top bar to try and eliminate so much flex. We had to put a brace from the front cross bar to the top bar. I made all the brackets out of chromoly flat plate.

ty everyone for the help odell thank you very much for the close upsthats just what i needed. it looked like a shock on your is that rtue or is it rigid