a stage 2 cam for his stage3Raptor cam ?

Countdown to West Coast ATV Shootout November 8th, 9th, 10th, 11th 2012 in Puerto Penasco, Mexico

You are not logged in. [Log In] Planet Sand » Forums » Technical » ATV 4 Stroke » a stage 2 cam for his stage3Raptor cam ?

Direct Links to Platinum Sponsors

Arizona

California

Florida

Louisiana

Mississippi

Oklahoma

Oregon

H.O.D Racing

Utah

Wisconsin

Site Sponsors

Arizona

Clown Racing

Kenz Cycle Tech

California

Schack 'High Quality Kill Switches'

Louisiana

Dyneaux Services LLC 985-759-2991

Michigan

Missouri

Topic Options

Rate This Topic

#765843 - 11/27/07 06:48 PM a stage 2 cam for his stage3Raptor cam ?
skinraptor03 New Comer Registered: 01/17/06 Posts: 33 Loc: allyn, wa	A guy on another forum wants to trade a stage 2 cam for his stage 3. My question is would it be wise? I have a 11:1 673 port and polish full pipe and the other normal mods. I have a 727 cyl. I am going to install later. Should I trade him or wait until I go bigger? Thanks
Top

#765948 - 11/27/07 08:23 PM Re: a stage 2 cam for his stage3Raptor cam ? [Re: skinraptor03]
OverRaTeD Timeslip Auditor Registered: 01/02/05 Posts: 1384 Loc: Coeur d'Alene, Idaho	stage three is pretty close to the x-4 cam. I would trade him.
Top

#766000 - 11/27/07 09:08 PM Re: a stage 2 cam for his stage3Raptor cam ? [Re: skinraptor03]
sto'stimemachine Smooth Sucka Registered: 04/01/06 Posts: 1765 Loc: Portsmouth, Va.	If your motor is used for recreational use (trails) I'd keep the stage 2, if you're looking for more top end power than the stage 2 can deliver then swap for the stage 3. Be sure to check the clearance between the valve stem seal and the valve spring retainer. _________________________ Coal Shed Racing The little steam engine that could
Top

#766670 - 11/28/07 07:23 PM Re: a stage 2 cam for his stage3Raptor cam ? [Re: sto'stimemachine]
skinraptor03 New Comer Registered: 01/17/06 Posts: 33 Loc: allyn, wa	I'll be tradin him. Thanks guys.
Top